Danfoss TripleLynx CN Manual de Instalação descarregar pdf (Página 57)

Connecting the inverters

AEG PS (RS485)

Solar-Log

1000/500/200

Installation 57 of 268

Procedure

1 Open the inverter as described in the inverter instructions.

2 Pull the free wires through the wire opening in the inverter.

3 If you have made the cable connection yourself connect the wires as

shown in the following diagram:

Solar-Log™ terminal block connector

Inverter terminal strip

Terminal

 1

 R+

 4

 R-

 5

 T+

 6

 T-

4 If only one inverter is to be connected terminate this in accordance with the

inverter instructions.

5 Close the inverter if no other inverters are to be connected.

6 Insert the terminal block connector into the Solar-Log™ RS485 socket.

Connecting the inverters to each other (Solar-Log

500

, Solar-Log

1000

)

 Connect using a 4 wire, shielded data cable.

 Where to connect: Terminal strip inside the inverter (on the retrofitted

RS485 interface)

Procedure

1 Open the inverter as described in the inverter instructions.

2 Connect terminals R+, R-, T+ and T- of inverter 1 to the corresponding

terminals on inverter 2.

3 Connect the other inverters to each other in the same way.

4 Terminate in the last inverter in accordance with the inverter instructions.

5 Close inverters.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 267 268

Sem comentários

Danfoss TripleLynx CN Manual de Instalação Página 57