Danfoss TripleLynx CN Manual de Instalação descarregar pdf (Página 212)

Solar-Log1000: Configuration at the unit

Performing the inverter detection (Config./Start/Inverter detection)

212 of 268 Solar-Log

1000/500/200

Installation

10.4 Performing the inverter detection (Config./Start/Inverter detection)

Inverter detection is used to detect all inverters connected to the Solar-Log

1000

and assign them to the address numbers defined during inverter selection in

the “Initial configuration” dialogue.

The number and types of the devices are detected automatically, and memory

allocation in Solar-Log

1000

is optimised to make data storage as permanent as

possible.

If the number of inverters changes, the internal database needs to be restruc-

tured, and this can be a lengthy process depending on the amount of data al-

ready stored.

The “Inverter detection” menu is opened automatically after the initial startup

and the initial configuration. However, it can be opened again at any time af-

terwards.

Procedure

 In the menu, select Config./Start/Initial configuration

 For initial detection, the following dialogue box is displayed:

 Touch Start

 The following overview screen then appears.

All interfaces are scanned one after the other and any inverters found are

listed under the predefined inverter types. This process can last different

lengths of time depending on the inverters connected.

Important: For inverter detection, all inverters must be active. Detection can-

not therefore be carried out after dark.

After detection is complete, the number of inverters detected should be

checked in the list. If an inverter is missing, check the inverter setting and the

wiring ( Section 4) and repeat the detection process.

The other settings in the inverter configuration should be made only after all

inverters have been successfully detected.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 267 268

Sem comentários

Danfoss TripleLynx CN Manual de Instalação Página 212