Danfoss TripleLynx CN Manual de Instalação descarregar pdf (Página 203)

Solar-Log500: Configuration at the unit

Internal settings, deleting and PIN lock functions (“Internal” menu)

Solar-Log

1000/500/200

Installation 203 of 268

9.7 Internal settings, deleting and PIN lock functions (“Internal” menu)

This menu can be used to carry out delete and security functions.

9.7.1 Reset (Internal/Reset)

Using the menus on the unit, there are 3 ways of resetting the Solar-Log

500

 Delete data

In certain circumstances after an inverter detection, it may occur that incor-

rect or unusable data are displayed. In this case, the stored can be deleted

without having to reconfigure the Solar-Log

500

completely.

 Delete inverter

If another inverter detection procedure has to be started, it is possible to

delete the inverter data only, without having to delete the rest of the config-

uration.

 Restore factory settings

This is used to reset the unit more or less to its as-delivered state

(Page 258). The network configuration remains unaffected.

1 In the menu, select Internal/Reset

2 Select Delete data, Delete inverter or Factory settings

3 Select Yes

9.7.2 PIN lock (Internal/PIN lock)

Here, a 4-digit PIN code can be entered to restrict access to the configuration

menu on the Solar-Log

500

display.

This PIN code has no effect on the operation through the web browser.

This can be protected separately.

1 In the menu, select Internet/PIN lock

2 Select Active (select Inactive to remove the PIN lock.)

3 Enter a 4-digit PIN code

4 Press ENTER to save

For the PIN lock to become active, the Solar-Log

500

needs to be re-started.

After it is up and running, the PIN code is then required in order to open the

configuration menu.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 267 268

Sem comentários

Danfoss TripleLynx CN Manual de Instalação Página 203