Danfoss VLT HVAC Basic Drive FC 101 Especificações descarregar pdf (Página 19)

1.3.8 Control Terminals

IP20 200-240 V 0.25-11 kW and IP20 380-480 V 0.37-22 kW:

130BB622.10

Illustration 1.4 Location of Control Terminals

1. Place a screwdriver behind the terminal cover to

activate snap.

2. Tilt the screwdriver outwards to open the cover.

IP20 380-480V 30-90kW.

130BB624.10

1. Place a screwdriver behind the terminal cover to

activate snap.

2. Tilt the screwdriver outwards to open the cover.

Digital input 18, 19 and 27 mode is set in 5-00 Digital Input

Mode (PNP is default value) and digital input 29 mode is

set in 5-03 Digital Input 29 Mode (PNP is default value).

IP54 400 V 0.75-7.5 kW

130BC249.10

1. Remove the front cover.

Control terminals:

Illustration 1.5 shows all control terminals of the frequency

converter. Applying Start (term. 18), connection between

terminal 12-27 and an analog reference (term. 53 or 54

and 55) make the frequency converter run.

12 20 55

27 29 42 45 50 53 54

DIGI IN

61 68 69

COMM. GND

+24V

0/4-20mA A OUT / DIG OUT 0/4-20mA A OUT / DIG OUT

GND

10V/20mA IN

10V OUT

130BB625.10

BUS TER.

OFF ON

Illustration 1.5 Control Terminals

Quick Guide VLT HVAC Basic Drive Quick Guide

18 MG18A302 - VLT

is a registered Danfoss trademark

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 45 46

Sem comentários

Danfoss VLT HVAC Basic Drive FC 101 Especificações Página 19