Danfoss FP975 Manual do Utilizador

FP9757-Day Electronic ProgrammerInstallation GuideDanfoss HeatingMAKING MODERN LIVING POSSIBLE

FP97510GB3.7 230 Vac Fully Pumped System 3-Port Mid-Position Valve PUMPED Switch SelectionN L 1 2 3 4 5 6NLBOILERPUMPATCRMTMAINS fuse

Danfoss Heating11GBWIRING CONVERSIONS to be used when replacing the following programmers with the FP975. Some time controls are connected diff erently

FP97512GBTable ADANFOSS RANDALL FP975 (SET MODE)Fully Pumped Systems - ensure Pumped/Gravity switch is in ‘Pumped’ positionMAINS WATER HEATINGNOTEThis

Danfoss Heating13GBTable A continuedDANFOSS RANDALL FP975 (SET MODE)MAINS WATER HEATINGNOTEThis conversion applies only if...An additional terminal b

FP97514GBTable BDANFOSS RANDALL FP975 (SET MODE)Gravity DHW, Pumped Heating Systems - ensure Pumped/Gravity switch is in ‘Gravity’ positionMAINS WATER

Danfoss Heating15GBSMITHS IND. CENTROLLER 100 N L 3 - - 2 - - 1 4SMITHS IND. CENTROLLER 60 1 2 5 - - 4 - - 3SMITHS IND. CENTROLLER 10 N L 3 - - 2 - -

Part No. 8585v01s7-03 03/11Danfoss Ltd.Ampthill RoadBedford MK42 9ERTel: 01234 364621Fax: 01234 219705Email: [email protected]: www.heatin

FP9752For a large print version of these instructions please call Marketing on 0845 121 7400.Danfoss can accept no responsibility for possible errors

Danfoss Heating3GBInstallation InstructionsFP9757 Day Electronic Programmer Index1.0 Installation Guide ...

FP9754GBSpecifi cationPower supply 230 Vac ± 15%, 50/60 HzSwitching action2 x SPDT voltage free, Type 1BSSwitch rating 10-230 Vac, 3(1)ABattery back-up

Danfoss Heating5GBMK.9 or SET The FP975 is supplied fi tted with a Danfoss Randall SET wallplate. However the FP975 will also mount directly onto a Dan

FP9756GB3. The FP975 off ers direct plug-in replacement to the following models (see below):Manufacturer Model Fully Pumped Systems Pumped/Gravity Sel

Danfoss Heating7GBIMPORTANT NOTEIf the timeswitch to be replaced is listed below it may be worth considering a FP715 Si as an alternative to the FP975

FP9758GBEnsure that the power to the existing unit is switched off prior to removal.SYSTEMS RE-USING EXISTING WALLPLATEUse the table on page 6 to confi

Danfoss Heating9GB3.4 WiringAlways switch off mains fi rst and never fi t programmer to a live wallplate. N/OONT2E LINKALS 1 & 5ON A SET LATENL12345