Danfoss RZ1 Manual do Utilizador

Z-Wave Electronic Radio-Frequency Receivers (1-Channel) RZ1 and RZ1-HPInstallation GuideDanfoss HeatingMAKING MODERN LIVING POSSIBLE

RZ1 AND RZ1HP10GBIf you wish to exclude a device from the network that does not use the relay function of the RZ1, follow this procedure:1. Press th

Danfoss Heating11GB6. If this process fails then the RZ1 PROG LED will ash ORANGE fast. To acknowledge this press the PROG button. The LED will ret

RZ1 AND RZ1HP12GB5.1 Initiating a primary controller shift in an undened network using RZ1Should you wish to carry out a controller shift before a

Danfoss Heating13GB5.2 Initiating a primary controller shift with the RZ1 being promoted to the primary roleShould you wish to promote the RZ1 to th

RZ1 AND RZ1HP14GBBasic SupportBinary switch SupportAssociation ControlMulti-Channel Vn2 SupportMulti-Channel Association Vn2 ControlMulti-command Con

Danfoss Heating15GBBinding The act of linking a remote wireless unit (i.e. thermostat or time controller) to the RZ1 receiver channelCha

Part No. RZ1v04_InstallationDanfoss Randall Ltd.Ampthill RoadBedford MK42 9ERTel: 0845 1217 400Fax: 0845 1217 515Email: [email protected]

RZ1 AND RZ1HP2For a large print version of these instructions please call Marketing on 0845 121 7400.Danfoss can accept no responsibility for po

Danfoss Heating3GBIndex1.0 Specication ... 42.0 Mountin

RZ1 AND RZ1HP4GBRadio Controlled Room Thermostat Receiver Module RZ1 RZ1-HPSupply Voltage 230 Vac ± 15%, 50HzConstruction EN 60730-1, EN 300-220-1Max

Danfoss Heating5GB2.0 Mounting Instructions

RZ1 AND RZ1HP6GB1 234ELECTRONICSN LCOMZONE1 ONZONE1 OFFNote: For mains voltage applications link terminals L and 2. 2.1 Wiring RZ1

Danfoss Heating7GB3.0 Understanding your RZ1The RZ1 receiver unit uses a combination of coloured LEDs to indicate the current operating mode/output s

RZ1 AND RZ1HP8GB4.0 Connecting devices to the RZ1To establish a connection with another Z-Wave enabled unit (i.e. RET BZ), the RZ1 must be placed in

Danfoss Heating9GBOccasionally you may need to remove a thermostat or other Z-Wave device from the RZ1 receiver. To do this, follow the procedure belo